Discussion Locked
Multiple port configuration on Cisco 2950
0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Hello,
I can't configure multiple ports at a time, while can configure single port.
LonMAP2950#conf t
Enter configuration commands, one per line. End with CNTL/Z.
LonMAP2950(config)#int range f0/2-5
^
% Invalid input detected at '^' marker.
LonMAP2950(config)#int f0/2
LonMAP2950(config-if)#
Your help appreciated.