Discussion Locked

My HDD is now noDMA. Why ?

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

After I convert my 20GB/5400rpm Maxtor HDD file system in WinXP Home from FAT32 to NTFS, performance is deteriorated substantially...
Why? - I asked myself, ran a SiSoft SANDRA 2002 and it reports that no DMA support now for my HDD.
How to fix this problem, because previous HDD rate was around 20000, and now only pitiful 6500~7200...
My system is:
P4-1600/512(Northwood)
Intel D845GRG
128MB/PC2100
20GB/5400rpm Maxtor

5 replies

by thechas

First, for XP, 128MB is on the low end of RAM to have things run smoothly.
I recommend that you add as much RAM as you can afford.
(I have 768MB on my XP system)

Next, enter BIOS settings, and verify that DMA mode is enabled for the HDD.

Then, check in Administrative Tools, Computer Management, Disk Manager your HDD status and settings.

My drive is connected through a secondary controller, and I cannot verify the settings for a drive on the Primary IDE interface.

Chas

by jedurham36

I agree that 128MB of Ram is too low for XP. My guess is that because of the low amount of RAM, XP is swapping out to the drive too much. Just watch you activity light for the hard drives, if they are on almost all the time, you should either downgrade the O/S or add more RAM. Another problem could be that the drive has become badly fragmented. I did some very quick checking on the knowledge base and couldn't find anything about DMA, XP Home, and Hard Drives. My own machine (XP Pro) dosen't even list any DMA channels being used by the hard drives either. The lack of DMA channels used by the hard drive might be just another XP "quirk"

This discussion is closed to new replies.