General discussion


NAT on a Point to Point link

By rohit_2712 ·
all i want to ask is can i configure a Dynamic NAT with PAT overloading on both the sides of a point to point link for eg. a leased circuit or a dedicated link?
I once tried it but it caused a lot of mess.

Experts please help.

This conversation is currently closed to new comments.

Thread display: Collapse - | Expand +

All Comments

Collapse -

by Chris910 In reply to NAT on a Point to Point l ...

with the right hardware/configuration you could but why would you want to?

What are you trying to accomplish?

Collapse -

by rohit_2712 In reply to NAT on a Point to Point l ...

the situation is :- say i have got a site located in san jose and other in delhi, india and both of them are connected through VPN. i hav got 2 public ip addresses 1 on each end. now i ll hav to configure NAT on both the sides with PAT overloading to shield my internal network.

what should i do to solve this.

i created a dummy situation in my lab using 2 cisco 2600 routers that too without VPN, but it was not working, as i was trying to ping end to end i recieved an RTO.

experts pls help.

Related Discussions

Related Forums