General discussion

Locked

NDPS Error

By shunter ·
We currently have a NW5.1 with SP1 installed and trying to run NDPS. When we were running MW5 NDPS seemed to work ok, most of the time. We are trying to set up NDPS on NT4 with sp4 128M of RAM client 4.71. We are able to see the printer and start the automatic download of the driver but during the download process we get the following spools.exe error "The instruction at 0x77e78bf4 reference memory at 0x00000000. The memory could not be read". At this point we only have one choice, click ok andthe install exits. Also the spools.exe service has been stopped and we have to go and re-start it. Thanks for any and all help.....

This conversation is currently closed to new comments.

5 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

NDPS Error

by adasys In reply to NDPS Error

To be honest I never encountered this problem before but I had a suggestion. On the services section use stop the spools services and set it to manual and try to login back again.

Collapse -

NDPS Error

by shunter In reply to NDPS Error

The question was auto-closed by TechRepublic

Collapse -

NDPS Error

by papachuck In reply to NDPS Error

According to MS article Q234326 you need to install SP5 on the NT workstation to solve the problem......Good Luck....Chuck

Collapse -

NDPS Error

by shunter In reply to NDPS Error

The question was auto-closed by TechRepublic

Collapse -

NDPS Error

by shunter In reply to NDPS Error

This question was auto closed due to inactivity

Back to Networks Forum
5 total posts (Page 1 of 1)  

Related Discussions

Related Forums