Question Locked

Need help with Port Forwarding on Cisco 871W

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have replaced a Linksys wireless router with a new Cisco 871W. I was able to configure the router, wireless networking, and NAT without difficulty using the Cisco SDM software, but I cannot figure out how to set up the "Port Forwarding", as it is called on the Linksys, to direct inbound traffic to my mail server, FTP server, and Vonage appliance.

I have read through volumes of Cisco IOS commands, and even tried a few, but without specific education on these routers, I don't know if I am missing a step or misinterpreting something. Any help or insight would be greatly appreciated.

Thanks!

3 replies

by netman1958

From the CLI you would type:

ip nat inside source static tcp 192.168.1.112 25 64.00.00.00 25 extendable

Replace 192.168.1.112 with the real ip address of your mail server and 64.00.00.00 with the public ip of your router.

This discussion is closed to new replies.