5 replies
by acattr
If you can startup the computer fine, but when it loads windows it blanks out, then your resolution is set too high.
Login in safemode, and go to control panel, display, and set the resolution to 640x480.
Then go up from there.
PS: Playwith the refresh rate too.
by pstevenson
by thechas
Essentially, the messages mean the same thing.
There is either;
No Signal
Or a signal (resolution or refresh rate) that is outside of the specifications for the monitor.
Many monitors do not support all refresh rates at all resolutions.
It is always best to select the correct make and model monitor in Display properties.
This helps Windows select only supported video modes.
Chas
by pstevenson
by pstevenson
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending