Discussion Locked

new power supply won't power up, next?

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a P-3 computer that was turning it self off and on. I went for the power supply. I got it all booted up. It worked fine for about two hours and then became very very slow. Then it just cut out and would not power up again. I tried another power supply it still won't power up. The fan on the processor turns one time and cuts out. What do I look for now?? I have not got a clue of where to go from here. I really need some help.

1 reply

by traversetek

It sounds like you had an overheating issue, and now that may have turned into a fried component issue. If you have another m/b and processor, I would hook up the new power supply to those. My guess is that it will work just fine, and you'll know that the power supply is not the problem. Then you can start to narrow things down back at the old system by swapping processors, m/b, etc.

I once had an entire shipment of machines come from the manufacturer with protective plastic strips( thinkink-jet refills) still covering the thermal paste on the heat sinks. Come to think of it, have you checked that on yours? Good luck :-)

This discussion is closed to new replies.