General discussion

Locked

NIC

By cul8rm8e ·
my problem is : everytime i boot my machine my lan adapter shows on the takbar as network cable unplugged,if i pull out my connection from the hub and put it back in the status changes back to online(10 mbps) and all is ok.

now heres the odd thing this is on the server with DHCP and theres no prob assigning IP`s to clients even when showing as unplugged.

TAMARACK T6020 10/100 Fast Ethernet

under advanced properties i have options for full duplex,port speed(set to 10mbps) same as hub and Network Addresswith an option to leave with no value. what should this be?

why would this be the case?

any help would be much appreciated as pulling out and replacing my connection to the hub each time i reboot is a bit of a pain to say the least.

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

NIC

by Richard Zam In reply to NIC

Please did you check the programs or drivers which are being loaded when your computer is booting? I think there is a conflict with one of those programs that are loaded when your computer boots.
I had a similar problem with a generic network card and turned out to be a problem of mutual incompatibility with one of the drivers from my Internet cam.
When i updated the nic drivers, the problem was solved.

Greetings and good luck

Richard

Collapse -

NIC

by cul8rm8e In reply to NIC

Poster rated this answer

Collapse -

NIC

by cul8rm8e In reply to NIC

This question was closed by the author

Back to Desktop Forum
3 total posts (Page 1 of 1)  

Related Forums