Discussion Locked

no monitor

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I recently added 512 to 256 megs of ram into my clone P3 along with a secondary hdd. the pc booted but I've never recoverd the monitor the hdd spins and all the component led's light up but no monitor. I've tried everything from new power supply to new cables, along with all the checking and rechecking of connections ect... also tried a new prossesor. Is the mother board shot? The monitor is working fine on another system, tried working vid. cards any sugestions other than new tower?

4 replies

by dmiles

Check the memory modules to make sure they are the same,they can cause the montior not to show graphics
You will also want to check the motherboard manufacturer to check the maximum amount of memory that is supported by board,make sure that memory is seated properly

by oz_media

Eliminate the cause:
First unplug the second drive and reboot, if no go, reconnect it.
Second, pull the latest stick of RAM out, if it works, the RAM is the issue and you need to determine, the max amount of RAM suported, The front side bus speed of the RAM (PC100, 133, or?)
Third, try the new stick of RAM with th eoriginal removed, this will indicate f the RAM is conflicting or is too much for your mother board.

Good luck,
OM

by thechas

Is this an Intel based motherboard that uses RDRAM?

If so, the modules need to be either matched in both speed and capacity, or you need to use a single DIMM with a CRIMM module in the other socket.

If you are running W98 or Me, having more than 511MB of total RAM can cause a number of strange problems.
There is a bug in the core code that can be triggered with more than 511MB of RAM. The only supported solution is to reduce the amount of installed RAM.

Chas

by inletgrovehs

Do as Oz says to find out what has caused the problem. Have you checked to make sure the secondary HDD jumper is set properly (for either slave or master depending on how you installed it)?

This discussion is closed to new replies.