Discussion Locked

Nothing on monitor.

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My computer turns on but nothing shows on the monitor. The monitor works fine with another computer hooked up to it. I even sent the motherboard [on board video] in and it checked out fine. Could there be a problem with the wires that connect to themotherboard from the case?

7 replies

by ann777

It's possible... but seems pretty remote; check out your power supply if you thing that it's not outputting enough power. What kind of system? How many devices draw power etc.

Have you tried connecting another monitor to this system board? When you sent in your systemboard, did you specifically tell them that the external monitor you are using works fine on other computers but not from this systemboard? I'd check out the systemboard placing another monitor on it. Then if the second monitor does the same, then I'd suggest checking into the power supply.

by cg it

If your monitor works great with another computer, it's not the monitor or the monitor cables or connector. I suspect that it's the motherboard regardless of whether you sent it in and they tested it. Have a friend loan you a PCI or AGP graphics card and software. Load it up, hook up the monitor, if it works, its the onboard video that's the problem. If using a PCI or AGP video card resolves the monitor problem, possibly the board BIOS is not properly configured to use the on board video. To check this, (of course you have to keep using the PCI/AGP video card to see the bios) boot your computer. While the board BIOS starts up press the delete key (or which ever key the BIOS says to press to enter the setup utility). Check your BIOS to ensure that the on board video is enabled. If not enable it, save settings and exit the bios setup. Turn off your computer BEFORE the Operating system starts. Disconnect your monitor from the PCI/AGP card. Remove the PCI/AGP card from your computer. Thenpower on. With the on board video now enabled your monitor should work. The operating system will detect new hardware and load the appropriate drivers. After the operating system loads you can remove the PCI/AGP card video drivers using and Add/Remove software feature from the control panel. By the way, on board video usually shares system memory. Though problems with insufficent system memory to run the on board video are just so remote as to not be a consideration, it's worth while knowing how the on board video works to eliminate causes and find possible solutions.

by cg it

ooops...in my instructions I mentioned to disconnect your monitor from the loaned PCI/AGP vid card, take the loaned card out of your machine but neglected to say, hook your monitor up to the on board video connector before powering on your system. Sorry for assuming ( red faced).

by cg it

Further and another ooops for assuming, does your CPU fan or system fans turn on? Does your computer beep when it powers on? If so, how many? Your problems could also be BIOS initialization. Somewhere in the system initialization process there mightbe a hang. The CPU could be bad, memory could be bad.

This discussion is closed to new replies.