Discussion Locked

Old Scanner runs very slow on Win Xp PC

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I just bought a new HP 522a PC which runs Windows XP Home Ed. I have a 600 III + paraellel scanner. It ran fine on my old slow Win 98 PC but now it scans so slowly its terrible. I installed both XP, Win 2000 and other drivers but none fixed it. I also ran the suggested patches from the scanner suppliers Mustek.

Can anyone suggest a fix?

Thanks Bruce

7 replies

by qballrail

Unfortunately, XP is not terribly fond of parallel devices. USB may be the best way to go. If you've installed the appropriate drivers, you may have a hardware issue rather than software. How much memory is installed? XP runs ok on 128m, but you may seriously want to beef up your RAM. Many new PC's these days are being released with only 128. If doubling your RAM, doesn't resolve, then I suggest replacing your scanner.

Not the answer you wanted but hope it helps anyway..

by thechas

Start by making sure that the parallel port on the PC is set to EPP/ECP mode.

You can do this either by entering BIOS setup while booting, or look at the ports in device manager.

Do you have at least 2X the ram on the XP PC as you had with W98?
Scanners use a lot of memory. With XP, I would go so far as to install as much RAM as I could afford for the PC.

Your printer driver for XP may be getting in the way also. If possible, install a seperate parallel port card for the scanner.
Also, make sure that the printer is turned on when you want to scan. The port often works better with all devices turned on.

Chas

by hjs

You are lucky. My scanner would not work at all after going to XP pro. I just got a new USB model. Here in the US after all the rebates it only cost me $20.00.

This discussion is closed to new replies.