General discussion

Locked

Onboard Graphics

By andrewtmurray ·
I have a intel sr440bx motherboard
66/100-mhz system bus freq
micro atx
does anyone know how to diable on board graphic card,I now have ATI all in wonder pci
card and cannot enable Tv or video capture
just keep getting peripheral not found
ATIadvise me i need to totally remove
the onboard nvidia tnt graphics, Any suggestions would be very much appreciated

This conversation is currently closed to new comments.

5 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

Onboard Graphics

by dmiles In reply to Onboard Graphics

Open the BIOS control panel and locate the locate the graphics on board heading and disable it in bios panel.Hope this helps

Collapse -

Onboard Graphics

by andrewtmurray In reply to Onboard Graphics

The question was auto-closed by TechRepublic

Collapse -

Onboard Graphics

by jeffers In reply to Onboard Graphics

Firstly boot up into Windows using the onboard driver...then remove the device in device manager. When you are prompted to reboot say no and the shut the pc down. disable the onboard card this can be done by either a setting in the BIOS, as mentioned previously, or there may be a jumper on the motherboard. When you have done this install your new card and boot up into windows...your new card should be deteted and installed as with a usual new piece of hardware. The only problem you may have is if you have a Packard Bell because on some (if not all) there is not way to disable the onbaord graphics adapter.

Hope this helps..

Paul

Collapse -

Onboard Graphics

by andrewtmurray In reply to Onboard Graphics

The question was auto-closed by TechRepublic

Collapse -

Onboard Graphics

by andrewtmurray In reply to Onboard Graphics

This question was auto closed due to inactivity

Back to Desktop Forum
5 total posts (Page 1 of 1)  

Related Discussions

Related Forums