Discussion Locked

Outlook caused an invalid page fault

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am getting the following error message when closing Outlook 2000 on a Win98 2nd Ed computer:
Outlook caused an invalid page fault in module KERNEL32.DLL at 0167:bff9db61. It goes away after clicking close. I can't find anything about this specific error message in MS Knowledge Base. I have more info on the error message if you need regarding the registers. I'm just trying to make it stop or should I not worry about it. Could this indicate a bigger problem with the OS or hard drive?

7 replies

by maxwell edison

Microsoft Knowledge Base Article - Q279262OL98:

Error Message: Outlook Caused an Invalid Page Fault in Module Kernel32.dll

Cause:
This behavior occurs if you drag a folder from your hard disk to the Outlook bar without installing the Integrated File Management add-on.

Resolution:
To resolve this behavior, install the Integrated File Management add-on component to Outlook 98.

Link:
http://support.microsoft.com/default.aspx?scid=KB;EN-US;q279262

REMOVE SPACES from the pastedURL

by swomack

I don't know if any of your answers will work because I don't think they related to my specific situation. I have Outlook 2000 and answers 1 and 3 refer to Outlook 98. Answer 2 has something to do with IBM Dialer which I am not using. However, I probably will not get anymore responses so I'll try your suggestions and search the MS Knowledge Base some more. I'll also give you the points in case you have led me in the right direction. Thanks.

by maxwell edison

OR -

Microsoft Knowledge Base Article - Q277552

OL98: How to Troubleshoot Active Setup Problems in Windows 98, 98 SE or ME

The following are the error messages or symptoms that you may experience when you try to start Outlook 98:

Outlook stops responding (hangs).

You receive an invalid page fault in the Kernel32.dll.

You receive an invalid page fault in module < unknown>.

The program quits when other error messages are acknowledged.

Setup states that items were not installed after completion.

You receive errors when you try to add components.

Setup tries to connect to the Web installation site even if you specified Setup to run from your CD-ROM.

See link:

http://support.microsoft.com/default.aspx?scid=KB;EN-US;q277552

REMOVE SPACES - oh heck, you know that by now.

This discussion is closed to new replies.