Desktop

Ask something
Discussion Locked

Page faults in win2000

0 helpful
3 replies

by hakan

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi, When adding more memory to my Fujitsu-Simens Scenic S, OS is Windows 2000 sp2.
I have 128 MB and are adding 128 MB more, memory modules are the exact same. They works just fine when using just one of them!! But 2 together - not!
I've replaced the motherboard but didn't help.
I get Page Fault in nonpaged area.
Following error codes show up on the BSOD:
0x00000050, 0xFCDB9030, 0x804B0BE0, 0x00000000 at adress 804BB0BE0 base at 8040000

Antyone can help me out?
regards

//Hakan

3 replies

by jrodri1636

These are memory-behavior errors. They can be caused by too little RAM; damaged RAM; msimatched RAM; too little free hard drive space in the partition housing the swap file; poor memory management choices by the user; overheating; or (most commonly)programming errors. Usually, two programs are mentioned in the error message: Start troubleshooting with these, either by running repair utilities, replacing implicated modules, uninstalling the program(s) altogether for diagnostic purposes, or reinstalling one or both for diagnosis and/or repair. Nearly always, this problem will first appear soon after you have made software, hardware, or configuration changes to your computer, and can be traced to those changes. (NOTE: Virus infestation is one involuntary type of ?software installation? that should be considered.)

by hakan

I had to reinstall the computer and now everything works great....strang error though!

This discussion is closed to new replies.