Discussion Locked

PPTP VPN inside IPSEC VPN

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a remote office connected via Managed AT&T IPSEC VPN over T1. When W2K user attempts to establish PPTP tunnel to outside vendor over Internet inside this VPN it takes 3-5 minutes to connect. If W2K split tunneling is disabled, it connects immediately. Operation either way works, but long connect time has user upset. Any suggestions?

2 replies

by adembo

Why are you using split tunneling? What other network are your users needed while connected to the VPN?

by hozcanhan

if you dont have other remote users don't use split tunnelling . If you are forced to use split tunnelling you have to tell your AT&T support to configure your T1 port on both sides .

This discussion is closed to new replies.