Hi there,
I have 2 10/100 3com Superstack hubs that uplink to an Intel 10/100 switch. Network performance is pretty good, exept I have noticed when I am running the service packs for the PC’s off a server, I am getting a lot of collisions through the uplink port from the hub to the switch. Both hubs are experiencing this behaviour.
Also, I am noticing that the uplink only runs at 10Mbps, whilst the rest of the ports are at 100.
How would I get the uplink ports to run at 100Mbps andreduce the collision rate during large data transfers? Is it a duplex issue? Or should I connect a second uplink to each hub?
Any ideas would be greatly appreciated.
Thanks again!
Peter
