Discussion Locked

Printer/Copier/Scanner On P2P Network

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Savin 9965DP. It is a printer and copire with a NIC built-in. The Savin is connected to a Linksys router. I am unable to ping the Savin. Here are the settings:
ip address of the Savin 192.168.1.9
default gateway 192.168.1.1
Subnet 255.255.255.0
The router is set to DHCP. How do I configure the Savin to print from computers plugged into the Linksys router. Is there some setting I need to change on the router config page? Any help is appreciated. Thanks.

7 replies

by toivo talikka

The Savin support pages have very little information about printing. However, there are a couple utilities which may help you:

http://us.support.ricoh.com/html_gen/util/SDM/SDM.html

SmartDeviceMonitor for Client "enables users to print directly to printers".

SmartDeviceMonitor for Admin "simplifies all aspects of installation, monitoring, and management of network devices. SmartDeviceMonitor for Admin tells you precisely what printers are available, how they are configured, even toner and paper levels."

If you are not already using the last utility, that might have some options, assuming you can connect to your MFP across the network.

by kaseydoggett

These manuals do not provide any info on configuring the Savin 9965DP to work as a printer. I need help with the network settings please.

by kaseydoggett

I'm not sure if it is supposed to be able to do this, but I can't even ping the printer when I connect my laptop directly to the printer with a regular ethernet cable (not crossover cable). I'm thinking this Savin can't automatically obtain an ip address from the Linksys, but I'm not sure how to configure it to use a static ip.

by sgt_shultz

you can't print, right? not a xp firewall problem?
how do you know it is at that savin is at that ip address? can you get it to print a self test showing its ip configuration. i think you are on the right track with your thinking, ping is where you start and if you have link light most likely problem is no ip address or mismatched ip address..( are you sure the linksys is dishing out dhcp like you think (have you reset it just because). you gonna have to google the saving and roll up your sleeves and learn the config. you can just play with front panel menus probably to find what you need. unless the thing is only ocnfigurable thru a mfg interface...can you reset the savin to 'factory defaults'. do you have a link light?

by kaseydoggett

I figured out the problem. I just needed to give the Savin printer/copier a couple of minutes to reset itself after changing the ip address in front configuration panel. Thanks for all the replies.

This discussion is closed to new replies.