Networks

Ask something
Discussion Locked

Problems with Cisco NAM Setup

0 helpful
3 replies

by cdurski

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a NAM-2 installed in a 6500 series chassis switch. I was able to set up spans to start collecting data on our LAN.
Problem #1, When I select more than 4 VLAN interfaces to monitor from the span the web display takes 20 - 30 seconds to refresh. I've checked DNS, and disabled name-IP resolution as cisco recommends with no change in refresh time.

Most of our WAN offices are on MPLS, but we have 10 - 15 offices on cable modem or DSL. I can not get the NAM to see any netflow traffic from the Cable/DSL sites. I've verified that the netflow packets are being sent out from routers at those sites, I'm just not receiving anything on the other end.

Any ideas would be a huge help, I've been scouring the internet for NAM related articles for the last few days with no luck.

3 replies

by gcsnetexpert

Hi,

Can you just brief me what you want to do and send me the current running config of your switch so that i can suggest something on my email gcsnetexpert@gmail.com

Regards,

Anurag

by cdurski

I haven't resolved any of the issues. I didn't get a whole lot of responses here, and work has thrown other things to fix my way.

This discussion is closed to new replies.