Discussion Locked

Public and Private Zones in HP switches

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I would like to set up 4 hp 2600 series switches so that the client attached to a port is invisable to other clients and can see a Gb switch for server and router access.

If this is possible, how would you do it?

Thank You

Herb

3 replies

by hozcanhan

Herb , you can't completely make him "invisible" . You can put him in a separate VLAN , or a separate IP subnet and use an apropriate net mask for the users. Or you can use a different protocol for him and load the same protocol on the server.

by greybeard770

You can use a personal firewall software or the XP SP2 firewall.
But I think you will create more problems than you think you will solve.

by greybeard770

You can use personal firewall software (ZoneAlarm) or the XP SP2 firewall.
But I think you will create more problems than you think you will solve.

This discussion is closed to new replies.