7 replies
by thechas
The primary source of radiation is your CRTs.
Work at a reasonable distance, and minimise time spent on the back side of the monitor.
Replace your primary CRT monitor with a LCD monitor is the best.
If you work on wireless networks, keep the hub at least 10 feet away from where you normally work.
Same goes for the client wireless ports.
The next is getting ahold of clock and data lines inside the case. Keep your powered up probing inside the case to a minimum.
Do not run a high speed CPU with the case panels off any more than is necessary.
Chas
by ben mack
Thanks Chas, I was not worried for my own health or well being. The question was asked of me and I did'nt want or have a descent answer.
Thanks again,
Ben.
Hi as a manufacturer of CRT based displays we had to test our displays for MPRII(electrical) and X radiation. We found that even non MPRII certified displays emmited less radiation than the average flourescent light fitting and that the only place that xrays could be detected above ambient levels was at the anode cap of the CRT. The hype about radiation of all types was heightened by the media, also by the manufacturers in an effort to raise prices of displays in the mid 90's.
Please comment
Rich
by ben mack
Thanks Rich. The question above was asked of me but after spending a couple of hours searching the net and another hour or two in the library I found nothing much at all. I knew that this would be the best place to find out the right stuff from theright people. Thanks again.
Ben.
by b_pope
by ben mack
by ben mack
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending