Discussion Locked

recvry and stop err presario 0x0000007a

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello,
I have had many problems with the PC not booting. When I try and do a recovery, during the procees it will not find drivers for the USB connection. After the recovery is complete it will boot ok several times. I then go to the Windows updatesite to download the latest updates. The first one it downloads is SP1. After the download and install begins I get the following message and it just stays on the screen and does not move ahead.

"A problem has been detected and windows has been shut down to prevent damage to your computer.
Kernal_Data_Inpage_Error

If this is the first time you have seen this message........

Tech Info
Stop 0x0000007a (0xe1636dac) 0xc000000e, 0xbf931aa5, 0x0aeeb860
Win32k.sys address bf931aa5 base at bf800000 datestamp 3b7de698
Beginning dump of physical memory"
End of message.
This has happened three times and I am not sure if it is memory or hdd gone bad.
Thank You

7 replies

by tandmres

You might want to try running a scandisk on your hard drive - there may be some bad clusters.

The other thing I can think of is to make sure your jumpers and cables are hooked up correctly for your hard drives, and check your boot order and make sure everything is correct in your BIOS

Hope this helps.

by casemaker

Thank You, The comment below along with yours had me go to Seagate site and download diagnostic tools. The drive is bad.

by pctech

This is from Microsoft's tech support site.
"This Stop message, also known as Stop 0x7A, indicates that the requested page of kernel data from the paging file could not be read into memory.

One of the following conditions usually causes a Stop 0x7A: a bad sector in a paging file, a virus, a disk controller error, defective hardware, or failing RAM. In rare cases, a Stop 0x7A occurs when nonpaged pool resources run out."
... I hope this helps you

by casemaker

Thank You, Your comment had me go to Seagate site and download diagnostic tools. The drive is bad.

by jay_laptop

Yes, I have seen this a couple of times, the above answer from technet pointed me in the right direction I resolved the issue both times by setting no page file and rebootnig a couple of times before resetting a fixed page file

regards, Jay

by casemaker

Thank You, The above comment had me go to Seagate site and download diagnostic tools. The drive is bad.

This discussion is closed to new replies.