Networks

Ask something
Question Locked

Routing Table Question

0 helpful
1 reply

by mark720

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Two 2600's back to back in lab simulating serial connection. sh ip route gives me the following:

R2(2600):
C 10.0.0.50/32 is directly connected, Serial0/2
C 10.0.0.48/30 is directly connected, Serial0/2
C 10.0.0.52/30 is directly connected, Eth0/0

R3(2600):
C 10.0.0.48/30 is directly connected, Serial0/0
C 10.0.0.49/32 is directly connected, Serial0/0

Qustion is, why does it show both my subnet (10.0.0.48 /30) and the direct address of the other interface (10.0.0.49 and .50 /32)? Is this something that ocurrs on serial connections? Notice the ethernet connection to the 851w only shows the network and mask, not the other interface.

1 reply

This discussion is closed to new replies.