Networks

Ask something
Question Locked

Secure Addresses on Interface Cisco 800 series

0 helpful
5 replies

by mehdi.talei

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello,

I am wondering if there is an equivalent command of mac-address-table secure for Cisco 800 series.

The point is that I would like to connect some specific machines (with specific MAC address obviously) to an interface of my router. I would like also to put the maximum secure addresses (Not sure if it is possible as there is in Catalyst)

You help is most appreciated.
Mehdi

5 replies

by mehdi.talei

Hello,

thanks for your reply and the link.
The command "mac-address-table secure" is the one that I am looking for, but this command does not exist for Cisco 800 Series but only for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers.

I am looking for the equivalent command for 800 series.

Thanks again,
Mehdi

by mehdi.talei

Thanks again for your post!
These commands exist for Catalyst but it is not the same for 800 series routers!!! I need the equivalent commands for 800 series routers!!!

thanks,
Mehdi

This discussion is closed to new replies.