Discussion Locked

Sticky Keys- keyboard stroke delay

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have been working on an old compaq hinote vp700 laptop.
At first it seem that their was no response from the keyboard. Then after further investigation i found that if i held down a key for 2 seconds it would work. This might sound like a minor inconveniance but it makes typing a document extremely painful- not worthwhile.This problem is in both DOS and windows.
The harddrive has been reformat windows reinstalled and the bios reflashed.

Any suggestions please

8 replies

by skloo77

hi there,

for your particular case, i would subject the issue due to wear and tear of the keyb...

this is a very old laptop, pentium mmx. the keyb h/w is able to respond after a delay pause, this shows that h/w is still going on for u.
but the fact that the laptop is aging, the contacts of the keys could have like gone bad... poor contacts may be the reason.

it is not an issue with the drivers or bios. since it is the same when in dos environment.

so, its either u get the keyb replaced (which most likely no more warranty coverage) or get a new laptop.

by pctech26

Sounds to me that you have the sticy key feature on. To remove the sticky key feature, navigate to the following.

Under the control panel click on Accessibility Options. Should be the first option. Under the keyboard tab, uncheck the Sticky Key feature.

PCTech25

by pikanin

No change to the settings in windows will change the fact that the problem occurs in Dos. Thanks for the suggestion though

by been there

If your brave try this: Take the durn thing aprt and clean the printed curcuit pads under each of the key's (only use alcohol, make sure it's only isopropyl as others will melt plastic.)and Q-tips. you could use a clean paint brush to clean the board of dust and crumbs, first. Soda pop will cause problems to if spilt on key board. first clean with mild detergent then use alcohol to clean and remove any moisture.

This discussion is closed to new replies.