Discussion Locked

"Temporary" Network Drops

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm going to be adding network drops to a manufacturing floor. The floor is carpeted.

Unfortunately, the ceilings are too high to use "power poles" and network tray, and management doesn't want the building looking like an erector set. My network cables will drop down to the floor and be terminated at a RJ45(female) connector. The connectors will be housed in a regular box/gangplate combination. The drop is about 30 feet from ceiling to floor and we are probably going to put two to four network wires down each drop.

Basically, I'm looking for any ideas on items that would look nice, but would keep the network wires somewhat taught and free from moving around. I'm thinking of velcroing it the the floor so it would be easy to move when that time comes.

Any suggestions are GREATLY appreciated.

5 replies

by bfilmfan

Check to see what the local, state and federal code enforcement says you will do.

If you are in the US, OSHA takes a dim view of cables across a floor.

by hal 9000

While you can run the cable drops in flexible conjute you still have to look at the Health & Safety Laws in your area.

I don't know of any area where cables are allowed to run across an open floor legally. You may get away with doing something like this in a open Plan Office where you have 4 cubicles at one drop and a short lead from the socket but I don't know of a single instance where you can run cable along the floor in an industrial/commercial environment.

If you need to run from the drop points you need to make trenches and have trench covers over them to prevent any injury.

Col

by hal 9000

You will also need to check the Electrical Safety Laws in your area as well because most areas will not allow Network and electrical cables within 4 inches of each other and if there is High Voltage Mains [3 Phase] involved the distance gets greater.

by robo_dev

How does the power get to the floor? I would take a second look for any unused conduits in the floor or walls to use before stringing off the ceiling.

Alternately, you could put in a WLAN workroup bridge like a Cisco WGB350. The bandwidth is a bit limited, but it sure makes connectivity much easier. I have deployed WGBs for both manufacturing kiosks with ruggedized PCs in them and also for the 'printer in the back corner of the warehouse' that would exceed cat5 or cat6 cabling guidelines because of distance. Basically you can hang a switch/hub at the end of the bridge, saving big $$$ over fiber and it installs very easily.

by hozcanhan

JMD, I read your description of the premises. There is no solution to your temporary drops, neither power nor ethernet cables. First and straight forward remedy is using a wireless AP with security . If you are barred from using wireless then use ethernet over electricity ! You need a pair of adaptors on either side. Each costs around 175 USD. This way you got only one type of cable to bother with. NO ! Expensive ? Use a cascaded switch at the "center" of the temporary drops ! Here you go 3 solutions! Power poles ==> use Legrand's . you can go as high as 4m.

This discussion is closed to new replies.