Discussion Locked

Toshiba Satellite Pro 490 upgrade to 98

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have Toshiba Satellite Pro 490CDT with 4G harddrive and 64M RAM. Want to upgrade from 95 to 98SE. Largely because I want to be able to use the USB. Also hope for more stability and to be able to run more software (Stuff that won’t go with 95).

Am I going to regret this?

I’m happy to backup data and install from scratch because my current system is probably fairly messed up.

I’m aware of the BIOS and driver updates listed at
http://www.csdsupport.toshiba.com/tais/csd/support/98upg/1099w98.shtml

I intended to

- Backup my data, etc
- Format my drive
- Use my recovery disks to put a clean version of 95 on
- Then follow Toshiba’s procedure from the web page as follows

Before you install Windows 98:
1. Update BIOS
2. Update Toshiba Internal Modem Driver v90_w95.exe
3. Uninstall Toshiba Infrared Driver (if installed)
After you install Windows 98:
1. Update Yamaha Sound Driver 490snd98.exe
2. Install Toshiba Win98 Infrared Driver 780fir98.exe
3. Install Toshiba Win98 Utilities 490utl98.exe

- While installing the 98 upgrade I guess I’ll have to shove in the original 95 disk at some point to prove authentic ownership.

Questions

- Do I have a fair chance of success?
- Have I missed anything important from my procedure?
- Is 4G and 64M enough for 98?

Thanks

9 replies

by mdelyea

Yes, you should be OK. Your machine's specs are OK for 98. The 98 upgrade disk has its own serial number so you won't have to use your 95 disk.

by richardwaddy

Thanks. Have gone ahead. Am using a full installation of 98SE. But modem won't work (Have installed 98SE drivers found on a Toshiba website. Toshiba tech support advise me to use an upgrade disk so I'm going to try to get one. (Do you really have torate an answer as "Unacceptable" to be able to leave a comment. Seems a bit rough.)

by richardwaddy

Thanks. Have gone ahead. Am using a full installation of 98SE. But modem won't work. Have installed the 98SE modem drivers found on a Toshiba website. Toshiba tech support advise me to use an upgrade disk so I'm going to try to get one. (Do you really have to rate an answer as "Unacceptable" to be able to leave a comment. Seems a bit rough.)

by hereinoz

Wow, I wish everyone was as thorough researching an upgrade before they did it. Congratulations on the ground work!

You should be fine as the previous post says. 4GB is fine for Win98SE - the OS should take less than 1GB, giving you a reasonable amount for the rest. And while 128Mb RAM would probably be the sweet spot for Win98, there are plenty of machines out there running 98 on 64Mb and doing it fine. It actually runs OK on 32Mb but works the swap file pretty hard.

A clean install is the way to go if you can - get rid of all the baggage. I don't think there was an upgrade disk as such for Win98 - I reckon you will just be able to install from the 98 disk and that will be it.

You should really enjoy your "new" machine

by richardwaddy

Thanks for your feedback.

Have finally got there.

To anyone wanting to do this upgrade the following site is a good starting point;
http://www.csdsupport.toshiba.com/tais/csd/support/98upg/1099w98.shtml

First hurdle was that upgrades were prevented by Toshiba Tools being on the PC. These are a pain to remove. The procedure on one of Tosh's sites did not work. One of the discussions on TechRepub helped find a file that did work;
https://www.techrepublic.com/forumdiscuss/thread_detail.jhtml?thread_id=107646&message_id=649323

I tried installing 98SE onto a formated harddrive but then the modem wouldn't work even after installing Tosh's 98SE modem drivers.

So I put 95 back on using my recovery floppy and CD.

Next 98SE Upgrade refused to install on top of 95. So I get and try a 98 Upgrade disk. This works and modem works.

98SE still refuses to upgrade on top of 98 as I have it on my laptop. But I'm told that 98 with all the Microsoft patches is as stable/etc as 98. I've downloaded and installed patches from http://microsoft.com/windows98

by sgt_shultz

yes, you go!
naturally, if you reformat your hard drive during the install, you'll have to wait on installing the drivers until you are up and running on win98. it shouldn't be a problem doing it in that order.
here is how i would do it:
make win95 startup cd
boot from it, format hard drive. make folder called windows/options/cabs on harddrive and copy all files located in win98 folder on win98 install cd to that folder. very long copy process, lots of big files.
you need the win95 startupfloppy to do this so you get the format command and cd support, see?
flash the BIOS
boot again from win95 startup floppy, at command prompt change to windows/options/cabs folder
cd c:\windows\options\cabs
type setup.
if you run setup that way, from the cabs folder you made, then in the future, windows won't be asking you all the time for the installation cd. it'll just find the files it needs in it's 'installation' folder, the cabs folder, see?
other thing i can think of is, checkin BIOS settings to make sure no virus protection is turned on in there. you can turn it on after install is done but BIOS level virus protection will not allow modifications to boot record which is what you need to do during os install...
after the install is done and new drivers (which you have previously downloaded and burned on a cd if you can, otherwise you can put them on old hard drive added in as second hard drive or just download them when you need them)...

by sgt_shultz

do this stuff right away after install, imho:
1)install and update anti-virus software
2)get all critical windows updates and service packs for your machine by browsing to windowsupdates.microsoft.com and letting it scan your system for needed updates...go ahead and get ie6 if you use ie for your browser...this is going to be very lengthy process if you are on dial-up but do it anyway...
3)install windows 98 shutdown patch if you have any trouble shutting down windows 98 after installing anti-virus and all your programs...get if from www.microsoft.com/downloads
do all you windows updates.
4) check device manager for any bangs or yellow question marks. let us know if you have any.
5) backup your registry by following these:
boot tapping f8 key, then pick safe mode command prompt only from Start menu that hopefully appears.
at command prompt, type attrib -r -h -s /window/system.dat
then type attrib -r -h -s \windows\user.dat
then type copy \windows\system.dat system.new
then type copy \windows\user.dat user.new
that backups up system.dat and user.dat your two registry files. reboot.
let us know if you have any problems.
you could just install over win95 even if your system is 'messed up'. i think it would be ok. but not a bad idea to start from scratch.

This discussion is closed to new replies.