Discussion Locked

unable to initiate tcp/ip

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
OS - NT, Computer - IBM 300PL I have a user who gets the "unable to initiate tcp/ip" about once a week when she trys to use a program called Superview. If she loggs out of all programs that are open (except Lotus Notes) she then can go back in and use the program. This does not effect any program except this one. I have reinstalled Superview several times, and have reinstalled all software once. What should I do next. (I am thinking of replacing the network card.) No one else has this problem.

3 replies

by salochin

Could be a possile resource issue. If you have a lot of other programs running at the same time and the program is very resource hungry, then the message can be displayed due to certain parts of the program not loading correctly due to RAM, for example.

I use TrayClock to monitor how much CPU and RAM I'm using at any given moment and always try to keep the bar approx. half to three quarters of the maximum.

If you load the TrayClock and then all the other programs you usually run, you willbe able to see how much memory is left. If you then run Superview, you will now see how much RAM the program consumes and it will probably point to the fact that you need more memory installing.

by trippin

Any other pc that is the same make and model??
If yes, clone the C:\
Should solved your problem.

by tlenocke

I fig. out what the problems was. Another program was using the port that Superview wanted to use. The other program would pick a different port if if Superview took that port, but superview was not that smart.

This discussion is closed to new replies.