Discussion Locked

Upgrading Adaptec ARO1130 to 2100S

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi, Sorry to double post. I posted this in Discussion centre & I think I should have posted it here as it's a question.
I am trying to upgrade from Winnt4 to W2K but the ARO1130 raid/scsi isn't supported in W2K & I haven't found any 3rd party drivers. Adaptec say that I should buy the 2100S card, but didn't actually say that it is compatible with the Supermicro M/bd "Super P6DBS" & all Supermicro will say is that the P6DBS is discontinued & they don't know. Does anyone know if the 2100S card will work in the P6BDS m/bd, or have any other suggestions??

3 replies

by pgm554

The board has an Intel BX chipset and is compliant with the current pci specs.I can see no issue w/ MOBO compatability.

However, you would probably need to back up all of your data and restore from a backup as there is a good possibility that the format of the two controllers is different enough that the old RAID setup will not be recognized by the new one.And even if it does , you might run into problems later on down the line.
My advice, start from a new install.

This discussion is closed to new replies.