Question Locked

VTP mesages through a router

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,

I am studying for my CCNP and have not been able to find an answer to a VTP set up on a home lab.

I have 2 switches seperated by a router. I have switch A set VTP server and swicth B set as VTP client but cannot get VLANs to update to switch B.

I have tried setting the router to the same VTP domain, version, password etc and also tried it in transparent mode but still i cant get any joy.

Surely there must be a way?

Thanks,

Mo

5 replies

by netman1958

If the only connection between the 2 switches is through the router, then you don't have a trunk and VTP doesn't apply. To utilize VTP you need to have the 2 switches connected together and establish a trunk.

by mobr17

i have the switch port set to trunk and this is connected to a sub interface on the router encapsulated by dot1q as in router on a stick.
If two seperate offices are connected through a wan surely there must be a way for VLAN's to be shared between both offices through a router

by netman1958

are essentially broadcast domains. Routers don't forward broadcasts (although there is a way to forward certain types of broadcasts via the "ip helper" function). As far as I know, VTP isn't one of the supported broadcasts.

I won't say there's no way to do what you are trying to do, only that I've never seen it done. I can't think of any reason you would need to have computers on different subnets be in the same VLAN.

by mobr17

Cheers for your advice.

Always good to hear from those who are more experienced.

Thanks again,

Mo

This discussion is closed to new replies.