Discussion Locked

wha is going on with my freinds WinModem

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My freinds Computer keeps "losing track "of its modem and it is driving us nuts sometimes. She has a Lucent-Win Modem and the thing keeps saying modem not propperly installed and or not working, then after holding the enter key for about 30-40 seconds it makes a long beeeeping noise. and when it does finally work, it "stalls out on the internet. I have used my AOpen modem and it works fine, no stalling, so I eliminated the Possible net work issue. she is using windows 98 SE and has it updated. What in tarnations is going on?
I thank you for your time.
Lee Wilson

9 replies

by opatzg9

If it's an internal modem and you don't need the serial plorts, disable them. I forget how its organized but com 3 and 4 use the same interrupts as com 1 and 2 so if com1 is used by the mouse and 3? is used by the modem, the modem will act flaky. So if you disable at least com 2 and set the modem up for com 2. that should clear it up. Does the modem have jumpers for what com port it is or is it plug and pray? If its an external modem then I'ld have to think the modem is shot.
Good luck!

by m.conlon

You could also check the manufacturer's website (assuming that you can get the modem to work long enough) for updated drivers. You can also search the internet for known issues between that particular modem, win98 and the model computer.

by fenaikh

Hi
There are no external winmodem at all that is a fact.
The winmodem uses your CPU for processing so it is a software modem wich really depend on the driver. I guess since you have the Win98 SE you may need upgrade or update the driver.

moreinfo check here:
http://808hi.com/56k/ltwin.asp

Good luck

Mohamed

***Very Important NOTE *********
After you copy the URL a space or a %20 maybe gets inserted in the URL when you paste it into your browser. Delete any spaces or such characters from the URL for the page to be loaded.
***Very Important NOTE *********

by hansenkb

One of the biggest problems with Winmodems is Windows not installing them correctly. Check the properties of the modem, and see what Com port it is using. Do this by right clicking on My Computer and selecting Properties, or through Start / Control Panel / System to open the Device Manager. Then go to the Ports section. Check to see if the com port your modem is using is listed there. It probably isn't. The other possiblity is that the computer motherboard has two active com ports still running. Try going into the BIOS and disabling the port the modem wants to use.

This discussion is closed to new replies.