Question Locked

What can I do to determine the cause of my server slowdown

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have recently replaced an older 2003 server with a Dell 2950 with dual gigabyte nic's 4 gb of ram and 2 quad processors. The server is fine until more than 20 users login and start to work. There are only two applications on this server. One is a Microsoft Access database that only a few use and the other is a database app that most of the company uses. I suspect the server is too fast for the rest of the network. All the the switches are 10/100 switches. All the pc's connecting are Windows XP and some users come in through a Windows 2000 terminal server. Utilization goes from 2% up to 65% and no one can do their job. I can't see anything in the event logs that would indicate the problem. Can someone help, please?

3 replies

by el_duce

Did it start to slow down right after the change with the new server?
If so, can you tell me what the hardware/software specs for the Hard Discs are? Raid-config, what array, ...

by weigm

It is a Dell Poweredge 2950 with 2 Quad Core CPU's and 4 GB of RAM. I have 4 - 160 GB SATA drives in a RAID 10 configuration. Windows 2003 R2 Server is installed. There are essentially 3 applications that run on this server. One computes mileage, another is a MS Access database and the third is a program that handles all the accounting, warehouse management and move management. I installed the server last weekend. Previously it was on a Compaq server with 4 450 Mhz processors running 2003 R2 Server. This started on Monday. The systems runs just fine as long as we don't get more than 20 users on it. Then utilization goes up to 50 - 65% and stays there. All the workstations move to a crawl. The server has 2 - 1 Gig Nic's. I have them plugged into a small 1 Gig switch but all the users are on a 100BaseT switch or they come in on a Windows 2000 Terminal Server.

This discussion is closed to new replies.