Discussion Locked
0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My problem is that When I run the setup on my pc, windows xp hangs at the starting windows xp screen prior to selecting the hard drive to install to. I have tried swapping hard drives and cables. The jumper settings are correct on the hard drive. What could be the problem. I believe it maybe a faulty motherboard. The bios locates the hard drive properly.
6 replies
by qballrail
If you are running anything less than 400Mhz, good luck. It probably won't work. Make sure you have at LEAST 128M, but I recommend 256. Did you run another OS on it previously with success?
If so, it's not your MB.. You'd also get error messages. Your system probably doesn't meet the minimum specs for install.
by basket43
Yes running 256 mb mem, on an amd 1800 chip, have not been able to run another os on it. could it also be faulty memory
by mdmonte
I have had similar issues twice before - setup gets to the same stage each time and then dies ungracefully. Once on a PII 350, and once on a PII400, both with 128Mb of RAM. Both times it was faulty RAM. I take it that running the hardware compatibility check comes up clean?
by basket43
yep sure does
by basket43
This question was closed by the author
by basket43
Thanx for ya help all....it was faulty memory causing it all
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending
Discussion
How to make light speed agent go away
0 helpful
4 replies
Question
Floppy drive wont work on my 486
0 helpful
1 reply
0 helpful
1 reply
Discussion Locked
Ryzen 7 7700
0 helpful
2 replies
Question Locked
Issue fully resetting my PC
0 helpful
4 replies