Question Locked

Converting/Converter for using full height adapters in half height bays

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Our agency has procurred thousands of newer HP/Compaq computers. Unfortunately, they are smaller SFF cases which only have 1/2 height bays. We have many users that require dual monitors and we use adapter cards for this purpose.

Does anyone know of a conversion kit to convert a full height card to 1/2 height?

Personally, I would like to purchase USB dual monitor adapter which are cheaper than 1/2 height cards.

Any help would be greatly appreciated.

3 replies

by thechas

Many manufactures make dual height cards. The card is a half height card and comes with both a full size and a half size bracket.

If your graphics cards are no taller than the short slot, you should be able to adapt them. If the actual cards themselves are full size, there is no way to adapt them to physically fit in the short format chassis.

I would start by calling the manufacture of the card and see if they will send you the short slot brackets for your cards.

I have gone the other way around, and made my own full size brackets for some short slot cards I bought at a bargain.

I use a Greenlee "D" connector punch to make the hole in a flat blank bracket. The tough part of this is determining the correct location for the connector hole. A good way to start is to remove the bracket from the card and carefully install it in the slot. Then, measure from the top of the slot to the center of the connector. Drill the starter hole and make sure to orient the punch the correct way.

Chas

by w2ktechman

and what a fricken hassle it was to install a full height card into it.

the designers should be taken out and shot.

first, you will need a riser card. It comes with a backplate to turn the slots sideways (for full height).

now, on the POS model that I dealt with, you need to strip the entire computer to change this plate. Hdds, MB, PS, (I think the fans were left alone).

A long job for something that could have been simple with very little planning. It seems that they went out of the way to make it difficult.

Anyway, the part # for the 7600 and 7700 SFF models is PD824A

But since it was really not that hard, expect an hour for the first try and probably 35-45 minutes afterwards. I spent a little over an hour looking at how to 'cheat' and not totally pull the MB, but ended up pulling it anyway.

This discussion is closed to new replies.