9 replies
by tommyd Accepted solution
by captbilly1eye Accepted solution
What Operating System?
Does the situation happen following a reboot with the first print job or does it happen on consecutive print jobs following good ones with no reboot in-between?
The issue you described usually happens when a printer is left on all the time.
The simplest workaround for this issue is to turn the printer off before turning on the computer or restarting Windows. Once Windows has finished loading (when the icons appear on the Windows desktop), turn on the printer. If power cycling the unit does not correct the issue, try using a different or new parallel cable.
According to HP:
"This problem is usually due to a data signal generated through the PC's parallel port during the computer?s power on self-test, or while restarting The Operating System. In most cases, the data signal being sent determines if a particular device (or type of device) is attached to the parallel port. When the printer receives a string of data that it does not recognize, it will attempt to interpret the data and assign a character for the unrecognized signal. This results in garbage characters or symbols printing on the page."
I hope this helps.
by tommyd Accepted solution
by captbilly1eye Accepted solution
Does the situation happen following a reboot with the first print job or does it happen on consecutive print jobs following good ones with no reboot in-between?
You stated the printer is left on all the time... is the computer it is connected to also left on all the time?
If not, the information from HP would apply. At which point, the only correction is to shut down the printer, restart the computer and then restart the printer after it has fully booted.
That is what I do when I have the same situation happen with any of my HP or Epson printers.
If on the other hand, if the computer that it is connected to is also on all the time, could the situation possibly be coinciding with an interruption in power like an electrical storm? If so, the HP recommendation would also apply.
Sorry... It's kind of hard to diagnose an intermittent problem without knowing the exact circumstances that are occurring to cause this issue to repeatedly happen.
by tommyd Accepted solution
by captbilly1eye Accepted solution
Were you able to solve the problem?
If so, what was the final resolution?
by tommyd Accepted solution
by captbilly1eye Accepted solution
I found the following troubleshooting page through HP:
http://tinyurl.com/vuyce
There are a lot of ideas there. Any you haven't tried?
My recommendation would be to replace the parallel printer cable with a newer, shorter one.
Also... just to verify... the printer is connected directly to this computer without a switchbox or network involved, correct? I believe you implied that this is a stand-alone set up, but I just wanted to be sure since those factors would definitely make a difference.
by tommyd Accepted solution
That is correct. It is a stand alone setup. No switchbox or network between the CPU & printer.
Thanks for the link. I'll check it out and see if I can figure this thing out.
This discussion is closed to new replies.
Trending Peripheral posts
Sort by Trending