Question Locked

power supply amp rating

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an lcd monitor that is spec'd for a 12V 3.75 A power supply. The 12V is pretty clear, my question is regarding the Amps raiting. From my understanding the 3.75A is the lcd max draw, so I can actually use another 12V supply with an amp raiting of 3.75 or more (4A etc). That is if a power supply that I get is rated at more then the 3.75A like 4A or 5A I can safely use it on the monitor with out any damage right? Amprs are 'pulled' by the monitor not 'pused' by the supply?

3 replies

by ozi eagle

Hi,

What you say is correct, as long as the replacement PSU has the same or greater Apm rating, at the same voltage it will work.

The thing that could cause you agro, however, is the polarity of the 2 psu's. Make sure that the plugs are wired the same way, ie that the positve goes, for instance, to the centre connection and the negative to the outside, or vice versa, to match the current psu, or the little diagram usually marked on the psu.

Herb

by mylittlemansanidiot

..connecting a PSU to anything that's not the correct rating.

There are 2 different types of power supplies, regulated and unregulated. A regulated power supply will produce it's rated voltage at any current draw up to it's maximum. ie. If the supply states it's 12V 5A and is a REGULATED supply, it will produce 12V whether is has a 1A load or a 5A load.

In an unregulated power supply, the voltage output is directly proportional to it's load. Because power (watts) is a product of volts x amp, an 12V 5A UNREGULATED power supply will ONLY produce 12V if the load being drawn is 5A. A lower current draw would result in a higher voltage output.

Then of course you have AC and DC currents to consider. These are generally noted on the PSU by a "squiggle" (or a syne wave) for AC and an equals sign with the top line broken for DC. In the case of a DC supply, polarity is an issue, but if the polarity is wrong nothing will happen because any electrical engineer worth his salt would protect the curcuit with a diode (which only allows flow of electricity in 1 direction).

The tricky thing is not all supplies will state if they are regulated or unregulated, so if you're unsure don't use it. Try to get either a genuine or after-market replacement for the PSU.

This discussion is closed to new replies.