Question Locked

printing from a laptop to a printer

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
trying to troubleshoot a networked printer by printing directly to the RJ45 jack on the printer from my laptop with a crossover cable , what settings do i need to change on my laptop if the printer allready has a staic IP programmed into it ? I have the correct driver loaded for the printer allready.

4 replies

by hal 9000

IP Address and change the connection from whatever it is the Ethernet or Network Printer.

Col

by daguerro

The IP address must conform to the IP address of the copier/printer. Make your laptop 1 digit off for the last octet of your IP address but the all of the other octets the same. If the copier is 192.168.1.10 make your laptop 192.168.1.11. As well you must input the subnet mask, and the gateway will not make a difference in this case. You can manually change your IP address by going to your 'local area connection' in you 'network connections'> then right click > choose properties > then scroll down to TCP/IP > then configure > then change 'automatically obtain ip address' to 'specify address'. This is where you'll put in the IP address and the subnet mask, don't worry about any other settings. And be sure to set them back after your done testing. Good luck.

by sridhar_reddapani

yes,follow add printer wizard. choose network printer and give the IP address of the printer.
Thats it u can print...

This discussion is closed to new replies.