Question Locked

two network, wired and wireless: how to make it work?

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

can anybody help me how to configure this:

3 desktop with 1 ethernet card and 1 wireless adapter each
1 network printer (connected to the wired network)

settings:

the ethernet cards
are connected to a:
linksys 8 port switch (SD2008)

static ip address
10.0.0.1 -> 10.0.0.3
255.255.0.0

the wireless adapters ( Linksys WUSB54GC)
are connected to a:
linksys wireless-G Broadband router (WRT54G)

static ip address
192.168.1.101 -> 192.168.1.103
255.255.255.0
192.168.1.1 -> gateway

dns setting all key in.

problems: everytime the PC's are connected to the two network (wired & wireless):

-i would not be able to connect to the internet.
-i would not be able to print.

is there any configuration i need to set to make all my internet request go to the
wireless network and all my printing services go to the wired network?

i know alot of people would suggest "why must you this and that" or "just change the this and that"
but what i need is to make the network work properly (or my prof would give me a failing grade :p)

i know alot of people can help :p
thanx alot!

5 replies

by cg it

not creating 2 networks with 2 routers and this type of headaches.

get a wireless access point.

by leoarellanojr

thanks! but we could only put it on the alternative solutions of our documentation.
you see, the instruction is to make the two network function using only those things
listed above, although the ip setting was done by me. another group said they solved
it already but would not share the answer to my group. we know its abit of headache
but we hope somebody could help us how.

by cg it

you have 2 networks. both routers have a WAN port. Traffic must flow out the WAN port of one network into the WAN port of the second network to access resources on the second network, and vice versa.

How you set that up is based on understanding routing, addressing, firewalls [since these are consumer routers, firewalls are on by default]and sharing.

The other hint is that computers can only use one network[one adapter active at a time therefore can only connect to one network at a time]. Someone suggested bridging and that's a good hint in this case.

by ic-it

Since it is school work, I can only give you a hint.
You want to BRIDGE the two subnets together.

This discussion is closed to new replies.